How to Use

The *Activate™ 5000 Bleach Dilution System has been engineered specifically to meter and dispense 5.25% Sodium Hypochlorite NaOCl at a 10% (9:1) solution. The components within the sprayhead work in conjunction with the specially designed bottle plug and dip tube within the bleach cartridge to deliver the correct solution of bleach. If the sprayer or cartridges are obviously damaged or missing parts, do not use the system!

Step 1:

Fill the empty water cartridge with clean, cool tap water, and then insert the sprayer’s tube down into the water cartridge; lock the cartridge into the sprayer with the locking tab.

Step 2:

Remove the threaded plastic cap from the bleach cartridge.

Step 3:

NEVER puncture or tamper with the plug that is in the neck of the bleach bottle; it must remain intact in order for the sprayer to dilute the bleach at the proper 10% dilution rate!

Step 4:

Lock the bleach cartridge into the other side of the sprayer.

Step 5:

Pointing the sprayer away from you into a sink or basin, pump the trigger a few times to prime the system.

Step 6:

The sprayer is now ready to use as a broad-spectrum surface disinfectant on surfaces in accordance with the directions on the bleach cartridge.

Step 7:

Always store your bleach system and additional bleach cartridges at room temperature (60^o – 72^o is best).

Step 8:

Periodically test the sprayed bleach solution with a high-level chlorine test strip for available chlorine.

Note: The sprayer mixes the bleach with the water to a 10% (1 part bleach to 9 parts water) solution (minimum 5,000 ppm available chlorine), so the water cartridge will have to be filled 9 times before the bleach cartridge is emptied.